Jet Ski Cover: Keeping Your Ski Safe For The Winter

The winter is no time for you to go jet skiing. The water and the air is simply too freezing for you to enjoy a high speed ride on the water during the winter so you might as well store your jet ski somewhere safe for the season.

However, before you put on your jet ski covers and store your jet ski in your garage, there are a few things that you need to do to make sure that your engine stays on top condition. Note that simply putting on jet ski covers and storing your jet ski in a safe place is not really enough to ensure that your craft will still function well later on. Cold weather has a nasty effect on motorized crafts.

Preparing Your Jet Ski For Storage

Before putting on jet ski covers on your jet ski, you need to drain the engine and clean the jet ski first. As soon as you take the jet ski off the water, drain the water from the engine carefully. You can do this by tilting the jet ski on its trailer. Raise the bow of the jet ski higher to ease the water out. Leave the jet ski in that position for a wile to get as much water out of the engine.

While in this position, turn the engine of the jet ski on. Turn the handle back and forth to release water that is trapped in the engine. Repeat the process several time to make sure that all the water is drained off the engine. When draining the water off the engine, avoid letting the engine run for more than 30 seconds at a time. Keeping the engine running for more than 30 seconds may cause the engine to overhead so be careful.

Once you are sure that there is no more water inside the engine of your jet ski, you may now proceed with the cleaning process. Always remember that putting on jet ski covers without cleaning your jet ski first may cause rusting and damage to your engine. If you don't want to end up with a jet ski with corroded parts at the end of the winter, clean off the grime from the jet ski before putting on the jet ski covers.

Use soap and water to wash your jet ski thoroughly both in the inside and the outside. After washing your jet ski, use some absorbent cloth to wipe it dry. After drying it off, wax the jet ski then put oil and lubricants into its metal parts before you finally put on the jet ski covers.